Septic Tank Risers for Sterling Homes
If your septic company has to dig up the lid every time they visit, a riser can pay for itself. Risers extend the tank openings to the surface and are capped with lids that lock.
Request a call and a company working in Sterling will explain the options and install risers on your tank.
What risers do for a septic tank
Risers extend the tank openings to ground level. Instead of searching for and digging up buried lids at every service visit, the crew simply unscrews a lid at the surface. Most risers are plastic, though concrete versions are also used, and each opening on the tank can have its own riser.
Benefits of adding risers
Risers cut the time and cost of every pumping and inspection, since no digging is needed. They make it easy to check the effluent filter, spot problems early and show inspectors the tank during a home sale. They also protect your lawn from repeated digging.
A typical riser installation
Most riser jobs take a few hours. The tank openings are dug out, the riser is sealed to the tank, trimmed to sit at or just above grade, and a locking lid is installed. Doing it the same day as a pumping saves a second dig.
Riser safety
Septic tanks contain gases and deep liquid, so lids must stay secured. Use lids with screws or locks, replace cracked lids promptly and never leave an opening uncovered. Keep vehicles off riser lids unless they are rated for traffic.
Is a riser worth it
For most homes with buried lids, yes. The savings from not digging on every visit, plus easier inspections, often cover the cost over a few pumpings. Ask your septic company to compare the cost with what you pay for digging now.
Questions to ask about risers
Ask how many openings your tank has, which should get risers, what material they use, and whether lids are secured with screws or locks. Ask if they can install during your next pumping.
Plastic or concrete risers
Plastic risers are lightweight, easy to trim to height and do not corrode, so they suit most existing tanks. Concrete risers are heavy and durable but harder to install and can let in water if joints are not sealed well. Your septic company can recommend the right option for your tank.
After the risers go in
Make a note of where the lids are for future owners and service crews. Mowing around them is easy if they sit flush, and they make it simple to check the effluent filter or water level. Report any loose or damaged lid to your septic company.
Is your tank a good candidate
Most tanks can take risers, but the value depends on how deep the lids are and how often the tank is opened. Ask your Sterling septic company how deep your lids sit, how much digging costs on each visit, and whether an effluent filter is installed. Those answers usually make the decision easy.
Risers and routine service in Sterling
Once risers are in, a Sterling septic company can open the tank in minutes. That makes it easier to keep a regular pumping schedule and to check the baffles and filter each time. Some homeowners add a riser over the outlet filter too, so it can be cleaned between pumpings.
Risers and lids for Sterling weather
Where soils are rated very limited, as most mapped soils near Sterling are, frequent checks of the tank and filter help protect the drain field. Risers make those checks quick. Sterling gets about 17 inches of precipitation a year, so risers here are mainly about access and saving the cost of digging. With about 3 months below freezing, an insulated lid can help protect the tank opening in winter.
Local conditions in Sterling that affect septic riser and lid installation
Among the mapped soils within about two miles of central Sterling, the USDA soil survey rates 69% as very limited for septic absorption fields, 12% as somewhat limited and 19% as not limited. The most common drainage class is somewhat poorly drained. Soils like these often call for careful system design, such as a larger drain field, a mound or another engineered system, and a site evaluation before any new installation or replacement.
Sterling averages about 17 inches of precipitation a year, and May is usually the wettest month. Average temperatures stay below freezing for about 3 months a year, with December averaging 30°F, so tank lids and shallow lines benefit from a layer of snow or mulch rather than being cleared bare.
Sources: USDA NRCS Soil Survey (SSURGO), Soil Data Access; NASA POWER long-term climatology. Soil ratings describe mapped soil types near the city center and do not replace a site evaluation of your property.
What the soil around Sterling means for septic riser and lid installation
By drainage class, the USDA soil survey maps the land around Sterling as 34% somewhat poorly drained, 27% well drained, 23% moderately well drained, 8% excessively drained, 4% poorly drained, 4% somewhat excessively drained. Risers bring the tank lids to the surface, which makes regular pumping and inspection quicker and cleaner.
Source: USDA NRCS Soil Survey (SSURGO), Soil Data Access
Septic companies near Sterling
We do not have a septic company on file within 60 miles of Sterling yet. Send a request and we will find the closest companies for you.
About Sterling, CO
Sterling is in Logan County, Colorado. About 12,954 people live there, across 7.6 square miles of land (about 1,700 per square mile).
Septic Riser and Lid Installation questions in Sterling
- How long does riser installation take?
- Usually a few hours, often done during a pumping visit.
- Can risers be installed on any tank?
- Most concrete and plastic tanks can accept risers. Your septic company will check the openings and choose matching parts.
- Do risers help in cold climates?
- Insulated lids can help protect the tank opening. Ask your septic company whether an insulated lid makes sense for your area.
- Is SepticTank.com the company that installs risers?
- No. SepticTank.com connects you with an independent local septic company that serves Sterling. That company does the work and sets its own prices.